PIC16F87T-E/ML【PDF 169/200 页】IC MCU FLASH 4KX14 EEPROM 28QFN

8008H–AVR–04/11

ATtiny48/88

PCINT4: Pin Change Interrupt source 4. The PB4 pin can serve as an external interrupt source.

MOSI/PCINT3 – Port B, Bit 3

MOSI: SPI Master Data output, Slave Data input for SPI channel. When the SPI is enabled as a

Slave, this pin is configured as an input regardless of the setting of DDB3. When the SPI is

enabled as a Master, the data direction of this pin is controlled by DDB3. When the pin is forced

by the SPI to be an input, the pull-up can still be controlled by the PORTB3 bit.

PCINT3: Pin Change Interrupt source 3. The PB3 pin can serve as an external interrupt source.

SS/OC1B/PCINT2 – Port B, Bit 2

SS: Slave Select input. When the SPI is enabled as a Slave, this pin is configured as an input

regardless of the setting of DDB2. As a Slave, the SPI is activated when this pin is driven low.

When the SPI is enabled as a Master, the data direction of this pin is controlled by DDB2. When

the pin is forced by the SPI to be an input, the pull-up can still be controlled by the PORTB2 bit.

OC1B, Output Compare Match output: The PB2 pin can serve as an external output for the

Timer/Counter1 Compare Match B. The PB2 pin has to be configured as an output (DDB2 set

(one)) to serve this function. The OC1B pin is also the output pin for the PWM mode timer

function.

PCINT2: Pin Change Interrupt source 2. The PB2 pin can serve as an external interrupt source.

OC1A/PCINT1 – Port B, Bit 1

OC1A, Output Compare Match output: The PB1 pin can serve as an external output for the

Timer/Counter1 Compare Match A. The PB1 pin has to be configured as an output (DDB1 set

(one)) to serve this function. The OC1A pin is also the output pin for the PWM mode timer

function.

PCINT1: Pin Change Interrupt source 1. The PB1 pin can serve as an external interrupt source.

ICP1/CLKO/PCINT0 – Port B, Bit 0

ICP1, Input Capture Pin: The PB0 pin can act as an Input Capture Pin for Timer/Counter1.

CLKO, Divided System Clock: The divided system clock can be output on the PB0 pin. The

divided system clock will be output if the CKOUT Fuse is programmed, regardless of the

PORTB0 and DDB0 settings. It will also be output during reset.

PCINT0: Pin Change Interrupt source 0. The PB0 pin can serve as an external interrupt source.

Table 10-6 and Table 10-7 relate the alternate functions of Port B to the overriding signals

shown in Figure 10-6 on page 66. SPI MSTR INPUT and SPI SLAVE OUTPUT constitute the

MISO signal, while MOSI is divided into SPI MSTR OUTPUT and SPI SLAVE INPUT.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购